Error message: Cannot connect to CM

Hi,

DP 8.0 is running on HP-UX on vPAR 6.0 on Integrity BL890 ic4 npaR. I installed UI on a Windows7 PC. When connecting i get the following error message below and as attached:

"Connection to CRS failed.

To start the DP daemons on the CM host use the command omnisv -start on the CM

or check if the communication between the CM and client is encrypted with the command

omnicc -encryption -status  -all on the CM".

I did all what i could by disabling encryption and by allowing access from ANY to ANY, but still i could not connect.

Please help!

Yaboto.