We are trying to setup the EMC Integration for Omniback 3.10 and are running into a problem when it tries to resolve objects we receive the
following;
[223:125] SYMA-R1 Resolving of object /u02_ux41 has failed.
Symmetrix configuration error.
(for /u0[2,3,4,5]_ux41).
It then aborted all 4 of the objectes and failed. I and the EMC Engineer onsite can't figure out what it is really complaining about, but that is because there is really very little output in the debug and emc integration logs. If anyone has seen something similar, any help would be much appreciated... For any HP employees, there is a case open on this (Call ID: 3100516991), but we are grasping at straws to figure out what is really going on and I have found the forums to be as helpful(if not more so) as the support line (due to a wider audience).
following;
[223:125] SYMA-R1 Resolving of object /u02_ux41 has failed.
Symmetrix configuration error.
(for /u0[2,3,4,5]_ux41).
It then aborted all 4 of the objectes and failed. I and the EMC Engineer onsite can't figure out what it is really complaining about, but that is because there is really very little output in the debug and emc integration logs. If anyone has seen something similar, any help would be much appreciated... For any HP employees, there is a case open on this (Call ID: 3100516991), but we are grasping at straws to figure out what is really going on and I have found the forums to be as helpful(if not more so) as the support line (due to a wider audience).